Prim’Sealer – Blanchon

Odorless water-based primer for wooden floors

Recommended when the original tone of a light-colored wood needs to be maintained.

Prim’Sealer – Blanchon

Odorless water-based primer for wooden floors

Recommended when the original tone of a light-colored wood needs to be maintained.

5,0L

Prim’Sealer – Blanchon is an odorless water-based primer for wooden floors, recommended when it is necessary to maintain the original tone of a light-colored wood. It is intended for use in combination with BLANCHON BELMONT™, INTENSIV™, SPORT™, BLUMOR® SD wood floor varnishes…

Tools

Roller, Spatula

Cleaning
tools

Water

Drying between coats

30' - 90' min

Back in
service

30' - 90' min

Number of
layers

1-2
BENEFITS
  • Odorless
  • No mixing, one component
  • Coated in only 1:30 hours
  • Maintains light-colored woods in their original shade
  • Applies to all European wood species
INFORMATION

Prim’Sealer – Blanchon is an odorless, colorless water-based primer for wooden floors, recommended when you want to preserve the original tone of a light-colored wood. It is intended for use in combination with BLANCHON BELMONT™, INTENSIV™, SPORT™, BLUMOR® SD wood floor varnishes… Its technical performance and composition meet the strictest ecological criteria. It is used on all types of European wood (if you intend to use it on walnut, contact our Technical Department).

Preparation

  • Sand the old or new wooden floor to obtain a smooth, even surface: first sand as bare wood with sandpaper grit 24 or 36, then with grit 50 or 60 and finish with grit 100 or 120. Then clean thoroughly.
  • The wooden floor must be perfectly clean and dry: as a general rule, the moisture content must be below 10% (do not use detergents or bleaches).
  • For glued wooden floors, use BLANCHON PRO FILLER (water-based filler) or BLANCHON RESIN FILLER for filling and colour matching (consult the Technical Data Sheets for these products).
  • Insecticidal treatment: If necessary, use a suitable treatment product.
  • Wood Staining: Floors sanded to bare wood can be stained with BLANCHON AQUATEINTE™ 2K wood stain. In this case, when the AQUATEINTE™ 2K has dried, apply PRIM’SEALER and then the selected floor varnish.

 

Application

  • Prim’Sealer – Blanchon is ready to use. Shake the container well before use. Do not dilute.
  • Do not apply to wooden floors if the temperature is below 12°C or if the relative humidity is higher than 85% (according to the current DTU).
  • Do not use on wood with a moisture content higher than 10%.
  • Apply a generous coat of Prim’Sealer – Blanchon by roller directly onto the wood. Then apply 2 coats of the chosen finish.
  • Prim’Sealer – Blanchon can also be applied with a smooth trowel. In this case, two cross-coats are necessary.
  • Do not apply Prim’Sealer – Blanchon by trowel on beech, maple or cherry.
  • Close the container tightly after use.
  • Cleaning of tools: Clean tools with water immediately after use.

Complementary products