Aguaplast Super Repair

Quick-drying and multi-purpose filler for exterior use

It is a cement-based filler, used for reproducing and shaping cornices and edges of balconies, columns, pillars, etc. without formwork or molding.

Aguaplast Super Repair

Quick-drying and multi-purpose filler for exterior use

It is a cement-based filler, used for reproducing and shaping cornices and edges of balconies, columns, pillars, etc. without formwork or molding.

COLORS

White
White

1,0Kg – 5,0Kg

The fast-drying and multi-purpose Aguaplast Super Repair exterior filler adheres and is applied to all types of substrates. It is used for the reconstruction of decorative elements and volumes of facades and statues, fills holes and cracks of any size and shapes cornices and edges of balconies, columns, pillars, etc. without formwork or molding.

DOWNLOAD THE SAFETY DATA SHEET (On request) HERE

Tools

Putty knife, Spatula, Trowel

Cleaning
tools

Water

Drying between coats

30' minutes

Back in
service

24 hours (3 hours in thin layers)

Number of
layers

1-2
BENEFITS
  • Cement-based filler
  • Fast drying and rapid acquisition of mechanical properties
  • Excellent bonding strength to all types of substrates
  • No thickness limitation. No shrinkage or cracking
  • Can be easily cut, shaped and chiseled
  • Flexible
  • Vibration resistant
  • A+ product
INFORMATION

The fast-drying and multi-purpose filling putty for exterior use Aguaplast Super Repair is cement-based. It dries quickly and immediately acquires its mechanical properties. It can be overcoated after 24 hours. It has no thickness limitation and does not shrink or crack. It can be easily cut, shaped and chiseled. The final finish is resistant to vibrations.

Preparation

  • The substrate must be cohesive, stable and free from dust, grease, wax or any other substance that prevents the proper adhesion of the filler.
  • Remove loose or poorly adhered parts of plaster, mortar, old paint layers, etc. Apply DELTAFIX or another stabilizing primer to stabilize weak and chalky substrates. If necessary, treat absorbent substrates with FIXACRYL or another stabilizing primer to reduce surface absorption. Soak or dampen the substrate before application to reduce absorption.
  • All areas contaminated with mold and/or moss must be thoroughly cleaned and then treated with FUNGISTOP or another antifungal agent.
  • Repair and seal dynamic cracks with AGUAPLAST FIBRA or FLEX FILL.
  • In general, substrates should be treated and prepared in accordance with local standards. If in doubt, it is highly recommended to carry out a test application on a small area to determine suitability, compatibility and application conditions.
  • The use of alkali-resistant mesh is recommended for reinforcing specific points such as structural joints, joints between dissimilar materials, window frames, lintels, etc.

 

Application

  • Use clean water, container and tools to mix the product. Mix in a ratio of 0.4 L water / 1 kg powder. Gradually pour the powder into water, stirring until a homogeneous paste without lumps is obtained. The product can be used immediately. The paste remains workable for approximately 30 minutes at 20ºC. High temperatures will reduce and low temperatures may extend the working time. Do not re-stir the mixture. Do not add water or powder once the product has started to set. Do not add excessive water to avoid shrinkage.
  • Apply using a trowel, stainless steel spatula or blade.
  • Clean tools with water immediately after use.
  • When working indoors, allow ventilation to ensure proper drying.
  • Can be overcoated with any type of paint or finish.

Complementary products

You may also like