Interkas_Intelligent_Wall_Primer_Sealer_2.5L
Interkas_Intelligent_Wall_Primer_Sealer_5L

Wall Primer Sealer

Microporous, waterproofing and stabilizing wall primer with high opacity and low odor

It is diluted with water, which exhibits excellent adhesion to most existing finishes.

Interkas_Intelligent_Wall_Primer_Sealer_2.5L
Interkas_Intelligent_Wall_Primer_Sealer_5L

Wall Primer Sealer

Microporous, waterproofing and stabilizing wall primer with high opacity and low odor

It is diluted with water, which exhibits excellent adhesion to most existing finishes.

2,5L – 5,0L – 10,0L

Wall Primer Sealer is a water-based, high opacity, low odour, waterproofing and stabilizing wall primer. It is particularly recommended for use prior to Little Greene water-based finishes for both interior and exterior applications. Suitable for the preparation of new renders, or even repaired surfaces, after appropriate preparation.

DOWNLOAD THE ΤΕΧΝΙΚΟ ΦΥΛΛΑΔΙΟ HERE

DOWNLOAD THE ΦΥΛΛΟ ΔΕΔΟΜΕΝΩΝ ΑΣΦΑΛΕΙΑΣ HERE

Tools

Brush, Roller, Spray Gun

Cleaning
tools

Water

Drying between coats

4 h

Back in
service

12 h

Number of
layers

1
BENEFITS
  • Manufactured under the auspices of the environmental quality management systems ISO 9001:2015 & ISO 14001:2015
  • Very low Volatile Compound Emissions (VOC 2 g/L)
  • A+ Product
A+_EMISSION
image_1
A+_EMISSION
image_1
INFORMATION

Wall Primer Sealer is a water-based, high opacity, low odour, waterproofing and stabilizing wall primer. It is particularly recommended for use prior to Little Greene water-based finishes for both interior and exterior applications. Suitable for the preparation of new renders, or even repaired surfaces, after appropriate preparation.

Preparation

  • Existing painted surface: Remove all loose and flaking paint. Degrease with a suitable detergent solution and then rinse with clean water. Sand thoroughly with medium grit sandpaper, e.g. 120-150 grit, to create a smooth, defect-free surface, paying more attention to areas where paint has been removed. Make repairs, sand and where necessary apply Little Greene Wall Primer Sealer to the exposed surface.
  • New plastered walls: For newly plastered surfaces, allow at least four weeks for the plaster to dry thoroughly. Apply a coat of Wall Primer Sealer diluted with 5 to 25% (by volume) water, depending on the porosity of the substrate. Apply by brush and roller to the entire surface and allow to dry.
  • This product is not recommended for application over lime-based or other natural plaster substrates.
  • Existing Painted Gypsum Board Walls: Lightly wash any existing paint to remove any dust or surface stains. Apply one coat of Wall Primer Sealer diluted with 5 to 25% (by volume) water, depending on the porosity of the substrate.

 

Application

  • Stir well before use.
  • Do not apply to surfaces when the ambient temperature is below 8°C or if there is a risk of rain during application or drying.
  • For good flow, apply a generous coat but avoid running the primer on the surface.
  • Brush application: Always use high quality synthetic bristle brushes that are the right size for the job.
  • Apply Wall Primer Sealer in even strokes, extending only the area to be painted so that a wet edge is easily maintained. For a higher quality finish, apply final strokes in the same direction and do not re-apply where the paint has already started to dry.
  • Light sanding between coats will remove any dust spots and other surface contaminants, creating an almost professional finish.
  • Roller Application: Use a short-pile fur paint roller for best results on smooth surfaces. Increase the roller pile size for rougher surfaces. Keep all final strokes of the roller in the same direction, maintaining a wet edge throughout, and do not re-roll where the Wall Primer Sealer has already started to dry, as there is a serious risk of streaking.

Complementary products

Interkas_Masonry_5L

Intelligent Masonry Paint

High quality acrylic water-based paint for exterior masonry surfaces

You may also like

Interkas_Intelligent_ASP_2.5L

Intelligent ASP

High opacity and low odor water-based matte primer and undercoat

Andromachis 217-219, Kallithea 176 73
Τ. +30 210 9521772, info@interkas.gr

Companies

Armourcoat

Beissier

Blanchon

Blatem

Clayworks

Coprabel’s Easy Color

Fleur Paint

Giorgio Graesan & friends

GUBRA

iD

Little Greene

MaxMeyer

Mr CLAY

OIKOS

Syntilor

TIMPEST

Valpaint

Viero Coatings

2024 Ιnterkas All Rights Reserved | Terms & Conditions

Designed and developed by DURAN

Andromachis 217-219, Kallithea 176 73
Τ. +30 210 9521772, info@interkas.gr

  • Companies
2024 Ιnterkas All Rights Reserved | Terms and conditions | Cookies policy
Designed and developed by DURAN