It is applied with a brush on small surfaces, skirting boards, etc…. and with a varnish roller on large surfaces.
Only the use of a floor sanding machine allows for the complete removal and exposure of the wood. It is a task that is recommended to be performed by a professional in the field.
The lifespan of your parquet and its beautiful appearance depend greatly on its maintenance. Use only suitable cleaners for wooden floors.
Under normal heating conditions at 20°C and 65% humidity, the minimum time required before the room can be used is 24 hours. This time period depends on both the temperature and the relative humidity of the room. If possible, wait 48-72 hours.
After complete drying, the hardening process of the floor varnish continues for approximately 7 to 15 days. This means that the floor varnish reaches maximum hardness in 2 weeks.
It is recommended that you be careful not to scratch the varnish film during the first 2 weeks after application.
The recoating time indicated on the packaging and in the technical brochures is the minimum required time. Once this time has elapsed, the surface must be properly sanded with sandpaper (grit 120-150) before applying the next coat.
No you cannot. Floor varnishes are not intended for outdoor use. It is recommended to use either Syntilor VERNIS BOIS varnish or VERNIS MARIN – Marine Varnish.
All Syntilor floor varnishes can be applied over Syntilor impregnation varnish. In case you want to use another company’s impregnation varnish, it is recommended to do a compatibility test beforehand. Syntilor impregnation varnish is applied in a thin layer and before applying the floor varnish it should be lightly sanded with sandpaper (grit 120).
Yes, different finishes (gloss levels) of Syntilor floor varnishes can be layered on top of each other, or even mixed.
Renovating old parquet by applying floor varnish without completely removing the existing layers is only possible if the existing surface is not worn down to the wood (if it is, even locally, you cannot). Clean the parquet using a suitable floor cleaner and sand with sandpaper (grit 120). Then apply two layers of floor varnish from Syntilor – Vitrificateur Ultra Resistant AQUARÉTHANE®.
2024 Ιnterkas All Rights Reserved | Terms & Conditions
